Freightliner M2-106 Chassis with 24’ Refrigerated Box

KEY VEHICLE SPECIFICATIONS

• Cummins B6 300HP @ 2600RPM
• Allison 6-speed automatic transmission
• Detroit drop single front zxle
• Detroit DA-RS-19.0 19000LB R series rear axle with 5:56 gear axle ratio
• Air brakes
• Chrome front bumper
• Two (2) 50-gallon aluminum fuel tanks
• Continental 11R22.5 Ecoplus radial front tires
• Continental 11R22.5 HC radial rear tires
• Cab air conditioning
• Cruise control
• Air suspension drivers seat
• Two-man toolbox midback non suspension passenger seat
• Back-up safety alarm with 7” color monitor
• 7” interactive touch screen display radio

BODY

• Exterior Body Dimensions: length 24’ | width 96” | height 96”
• Interior Body Dimensions: length 279” | width 88” | height 87”
• XPS thermal insulation type – 4” polyurethane insulation foamed in place
• Aluminum kick plate on front wall
• Galvanized sub-frame

FRONT WALL

• Outer Skin 0.08″ high strength and high brightness FRP board
• Inner Skin 0.08″ high intensity high brightness FRP plate (food grade) sandwich layer 4″ thick B2 Class flame retardant
• XPS Extruded board (foam density 35kg/m³)
• Glue YEBOND 2003N Inner Skin foot line 0.157″

SIDE WALL

• Outer Skin 0.08″ high strength and high brightness FRP board
• Inner Skin 0.08″ high intensity high brightness FRP plate (food grade) Sandwich Layer 4″ thick B2 Class flame retardant
• XPS Extruded board (foam density 35kg/m³)
• Glue YEBOND 2003N
  Inner Skin foot line 0.157″ patterned aluminum plate flow tank.

ROOF

• Outer Skin 0.08″ high strength and high brightness FRP board
• Inner Skin 0.08″ high intensity high brightness FRP plate (food grade) Sandwich Layer 4″ thick B2 Class flame
• XPS Extruded board (foam density 35kg/m³)

REAR DOOR

• REXKING 2 1/8” Insulated Rear Roll up Door with low temperature resistant rubber strip

REAR FRAME

• Rear Frame – 304 Stainless steel rear frame with gutter style header
• Bumper Blocks – (2) Standard Bumpers

REFRIGERATION

• Carrier Supra S8 Truck Refrigeration Unit
• 22,000 BTUH @ 35F, 14,000 BTUH @ 0F, 8,500 BTUH @ -20F
• Extended Service Interval (2,000 Engine Hours)
• Tier 4 Final Kubota Smart Diesel Engine – Three Cylinder
• 2-Cylinder Compressor 12.2 Cubic Inch Displacement with R-452A Refrigerant
• Maintenance Free Electric Evaporator and Condenser Fans
• APX Microprocessor with Data Recorder and Cab Command Controller
• High-Power 110 Amp Alternator
• Full Bottom Panel for Noise Reduction and Top Grille
• Auto Start-Stop Fuel Saver
• Complete Unit Installation & Pre-Delivery Run Testing
• Battery Box, Frame Mounted with Carrier PowerRush High-Cycle Battery
• 30 Gallon Aluminum Fuel Tank, 18 inch diameter, Center Fill, Frame Mount
• 10 Gallons Diesel Fuel, Start-Up and Test Run Fuel
• Electric Standby 230 Volt / 3 Phase / 60Hz

FLOOR

• Outer Skin 0.08″ high strength and high brightness FRP board
• Inner Skin 0.08″ high intensity high brightness FRP plate (food grade) Sandwich Layer 4.5″ thick B2 Class flame retardant
• XPS Extruded board (foam density 35kg/m³)+12mm high density bamboo plywood
• Glue YEBOND 2003N
• Bottom Frame 1.57″*1.57″*0.08″ Square steel welding
• Aluminum 1” T Floor
• Two (2) Drains with Kazoo

LIGHTS – EXTERIOR

• Number of front marker lights Top 2/Top 2+below 2
• Color of front marker lights Red/Yellow/White
• Number of rear marker lights Top 2/Top 2+below 2
• Rear position lamp color Red/Yellow/White
• Number of side marker lights Top 2/Top 2+below 2
• Side marker light color Red/Yellow/White

LIGHTS – INTERIOR

• Interior LED light (with switch) White

ETRAC

• Two Rows of Etrac installed on side walls @ 30” and 60” from centerline to floor

LIFT GATE

• Dhollondia RPH-33 3300LB Capacity 50″x85″ aluminum platform
• Side steps, dock bumpers and ICC Bumper
• Light Kit